STAR RF-Tiny PROXIMITY READER OPERATING AND INSTALLATION MANUAL RF-Tiny Proximity Reader Revision : 02 Date : November 16, 2001 ID TECK Co. Ltd.
STAR RF-Tiny PROXIMITY READER CONTENTS RF TINY-20011117 1. Introduction page 3 2. Identifying supplied parts page 3 3. Specification page 3 4. Installation page 4 5. Wire Color Table of the Reader page 5 6. Wire Connection to Controller page 5 7. Operation page 6 8. FCC Registration Information page 7 9.
STAR RF-Tiny PROXIMITY READER 1. Introduction The STAR RF-Tiny is an elegant looking and an attractive 4" read range proximity reader which can be mounted to metal door frame(mullion) or any flat wall surface. The RF-Tiny use the electronics module in epoxy potting that ensure you successful operation even in harsh environments. Two color LED of green and red, inside Piezo buzzer sound will guarantee you an accurate and reliable system operations. 2.
STAR RF-Tiny PROXIMITY READER 4. Installation 4-1. Mullion/Wall Mount Drill two 3mm holes 2.72"(69mm) apart in vertical and drill one 1/2" hole for the controller cable 1.36"(34.5mm) apart from the top hole. 4-2. Put controller cable into the center hole and install the controller module by using two 3-20 screws. 4-3. Put bezel into the controller module then push bezel until you hear the locking sound.
STAR RF-Tiny PROXIMITY READER 5. Wire Color Table of the Reader POWER Power(DC +5V~+12V) DC(+) Power(DC Ground) DC(-)(GND) INPUT Buzzer control input BUZZER LED control input LED OUTPUT(Wiegand Format) Wiegand Data-0 Data-0 Wiegand Data-1 Data-1 OUTPUT(ABA Track II Format) ABA(Card Present) CP ABA(Clock) CLK ABA(DATA) Data OUTPUT(RS232C Format) RS232C(TX) TX 6.
STAR RF-Tiny PROXIMITY READER 7. Operation 7-1. Apply power and you can see Red LED is on indicating the reader is in standby. 7-2. Present proximity card to the reader until you hear beep sound and the LED is changing the color to Green simultaneously and the reader send RF card data to the controller then LED changes the color to Red again for next reading. 7-3.
STAR RF-Tiny PROXIMITY READER 8. FCC REGISTRATION INFORMATION FCC REQUIREMENTS PART 15 Caution: Any changes or modifications in construction of this device which are not expressly approved by the responsible for compliance could void the user's authority to operate the equipment. NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; 1. This device may not cause harmful interface, and 2.
STAR RF-Tiny PROXIMITY READER 9. Warranty and Service The following warranty and service information applies only to the United States of America and Republic of Korea. For the information in other countries, please contact your local distributor. To obtain in or out of warranty service, please prepay shipment and return the unit to the appropriate facility listed below. IN THE UNITED STATES RF LOGICS Inc. Service Center 3026 Scott Blvd., SANTA CLARA, CA95054 Tel.: (408) 980-0001 Fax.
