User`s manual

5. Press the
<Enter>
key. The reader will beep twice to indicate the reader is
now in the Setup Mode for group X.
6. Type the
two-character selection code
for the feature that you wish to
change.
7. Press the
<Enter>
key. The reader will beep twice to indicate the code is
accepted by the reader as a valid code for Setup Group X.
8. Type the
one-character code
for the change you wish to make.
9. Press the
<Enter>
key. The reader will beep twice to indicate the code is
accepted by the reader as a valid code for that particular feature.
10. Repeat Steps 6 to 9 for any other features that you wish to change in the
same Setup Group.
11. Save the changes and exit Setup Mode by typing
XZ
. (Of course, X must
be the same group name entered in Step 4.)
12. Press the
<Enter>
key. The reader will sound four beeps to indicate
the new settings have been saved in the reader and the reader is back to the
normal reading mode.
EXAMPLE:
To set the reader’s beep volume to LOW, enter following setup code in
Notepad:
/E/D/FB<Enter>B1<Enter>1<Enter>BZ<Enter>
The setup routine is always the same, regardless of group:
1. Enter group setup mode.
2. Enter the feature selection code.
3. Change the setting for that feature.
4. Save the change and exit.
The reader’s response is always the same, regardless of group:
· Two slow beeps indicate the code has been accepted by the reader.
· Four slow beeps indicate the reader has saved the settings and has exited the
setup mode successfully.
· Four quick beeps indicate the code entered is invalid and has been rejected
by the reader.
Notes: Type codes in slowly (no more than two characters per second). If there
is a typing error, do not use the BACKSPACE key to correct it. Instead, press the
<ENTER> key. The reader will sound four quick beeps to indicate the error code has
been rejected. Then re-enter the code correctly.
For the numeric character in the code, use the number keys located on top of the main
alphanumeric keypad. Do not use the number keypad located on the right side of the
keyboard.
Before proceeding to enter the next code, make sure the reader gives the correct
number of beeps when <ENTER> is depressed.
5