User`s manual

ManualsBrandsID TECH Manualscomputers & electronicsMini-Mag System

MINIMAG

Magnetic Stripe Reader

TTL

User’s Manual

ID TECH

10721 Walker Street

Cypress, California 90630

(714) 761-6368

www.id-tech.net

80030501-005 Rev. A R02/05 #422

MINIMAG

Magnetic Stripe Reader

TTL

User’s Manual

ID TECH

10721 Walker Street

Cypress, California 90630

(714) 761-6368

www.id-tech.net

80030501-005 Rev. A R02/05 #422

Summary of content (4 pages)

PAGE 1
TM MINIMAG Magnetic Stripe Reader TTL User’s Manual ID TECH 10721 Walker Street Cypress, California 90630 (714) 761-6368 www.id-tech.net 80030501-005 Rev. A R02/05 #422 TM MINIMAG Magnetic Stripe Reader TTL User’s Manual ID TECH 10721 Walker Street Cypress, California 90630 (714) 761-6368 www.id-tech.net 80030501-005 Rev.
PAGE 2
Agency Approved OPERATION Speciﬁcations for subpart B of part 15 of FCC rule for a Class A computing device. Make sure the reader is properly cabled and is receiving sufﬁcient power. To read a card, slide the card, in either direction, through the reader slot, with the magnetic stripe facing the magnetic head. Limited Warranty ID TECH warrants this product to be in good working order for a period of one year from the date of purchase.
PAGE 3
DATA, CLOCK AND CARD PRESENT SIGNALS The following is a timing diagram of typical DATA and CLOCK signals from ID TECH electronics: CLOCK: The CLOCK output is narrow pulse normally high, and goes low when data is valid. The data level is stable at both the rising and falling edges of the CLOCK pulse. CLOCK pulse width is typically 32 microseconds. CARD PRESENT: The CARD PRESENT signal indicates data is being read from the media being passed through the slot.
PAGE 4
DESCRIPTION HOST CONNECTIONS The MiniMag™ compact magnetic stripe reader can read 1, 2, or 3 tracks of magnetic stripe information. Power, when the MiniMag is connected to the host via a decoder box, is obtained from the decoder box. Operating current is 4mA maximum for a 3-track conﬁguration. The undecoded MiniMag reader is connected to a decoder box using a 9-pin squeeze-to-release connector.