Magnetic Stripe Reader-Writer RS232 & USB-RS232 Interface Quickstart Manual ID TECH 10721 Walker Street Cypress, California 90630 (714) 761-6368 www.idtechproducts.com 80058504-002 Rev. C R01/08 Magnetic Stripe Reader-Writer RS232 & USB-RS232 Interface Quickstart Manual ID TECH 10721 Walker Street Cypress, California 90630 (714) 761-6368 www.idtechproducts.com 80058504-002 Rev.
TROUBLE SHOOTING FCC WARNING STATEMENT Refer to the installation instructions for Reader-Writer and for Workshop troubling shooting information. The RS232 or USB-RS232 operation has little Windows setup; however, review of the communication parameters may be necessary to insure the correct baud rate, parity, etc. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules.
LIMITED WARRANTY MAINTENANCE ID TECH warrants to the original purchaser for a period of 12 months from the date of invoice that this product is in good working order and free from defects in material and workmanship under normal use and service.
COMMUNICATION INTERFACE INTRODUCTION The USB interface uses PC compatible communication drivers, which emulate a RS232 COM port operation through an USB serial connection. This approach allows the application to communicate with the reader through a virtual COM port. Drivers are required for USB to operation. See the Reader-Writer User Manual for more information on installing the drivers.
UNPACK THE Reader-Writer WORKSHOP UTILITY Open the shipping carton and inspect the contents for any shipping damage. Remove and account for the contents of the shipping carton. The carton will include: The Reader-Writer and the Workshop software provide the card reading & writing functions most often needed for magnetic stripe use. These functions & operations are available from a single Workshop window.
