User manual

Copyright © 2010, International Technologies & Systems Corporation. All Rights Reserved
49 of 66
ID TECH EzWriter
Reader Responses on page 60 for details. This is the command version of power cycling
the reader.
Note This command byte is not recognized as a command within data strings.
# (23H) Configuration Request
ACTION Transmit a byte representing the configuration of the unit as follows:
Table 2 –Configuration Byte
Bit Position*
Bit = 0
Bit = 1
0 Track 1 Read not present Track 1 Read present
1 Track 2 Read not present Track 2 Read present
2 Track 3 Read not present Track 3 Read present
3 not used – should be 0 not used
4 Track 3 Write not present Track 3 Write present
5 Track 2 Write not present Track 2 Write present
6 Track 1 Write not present Track 1 Write present
7 parity bit** parity bit**
* bit 0 = lsb, bit 7 = msb
** is = 0 for units configured for 8 data bit transmission
Obtain details of the current unit configuration.
EXAMPLE The following byte (in hex) was returned: 63. It indicates a unit capable of
reading magnetic data on tracks 1 and 2; and writing magnetic data on to tracks 1 and 2.
& (26H) Card Edge Detect
ACTION The unit performs the following sequence: Transmit command
acknowledge (“^” 5EH). If not a reader/writer, then a Can’t Execute “~” reply is sent from
the unit. Wait for card swipe. Transmit Card Edge Acknowledge (“>” 3EH) after the unit
detects the card edge at the encode head. After a “Card Edge Detect”, command is
received and acknowledged. The only valid commands that are accepted for execution
are the “Abort” <ESC> and “Warm Reset” <DEL> commands. All other commands result
in an “Invalid Command” “!” response.
LED Commands. Use these commands to manipulate the reader’s LED.
L (4CH) Green LED ON
l (6CH) Green LED OFF
M (4DH) Red LED ON
m (6DH) Red LED OFF