Instruction Manual

Features
9
Setup is separated into many different categories ranging from "Interface" to "Cloning". The following is a list of function keys and
the setup category for which they apply:
Key
Category
F1
Interface
F2
Decoders/Scanner
F3
Editing
F4
Macros/Special Keys
F5
Strings
F6
Reserved
F7
Buzzer/LED
F8
Status/Diagnostics
F9
Cloning
F10
Reset All Defaults
For those categories which have more than one option, the UP and DOWN arrow and ENTER keys are used to move from one
option to the next. In addition to the UP and DOWN arrow keys, the CTRL UP and CTRL DOWN arrow keys are used to move to
the bottom and the top of the list. The following is a list of all special editing keys and a description of their function:
Key
Description
Left Arrow, Right Arrow
Toggles through the settings for the current option.
Up & Down Arrow
Moves from one option to the previous or next within the category or group.
CTRL Up & Down Arrow
Moves to the top or bottom of the category or group.
Home & End
Moves to the beginning or end of an input field.
ALT Backspace
Toggles the output mode during configuration, between destructive backspace and
non-destructive backspace. Defaults to non-destructive backspace.
CTRL + Keypad
Increases transmit speed during setup.
CTRL - Keypad
Decreases transmit speed during setup.
CTRL F7
Test the current Beep Tone and Beep Duration
CTRL F10
Resets the current option to the default setting.
SHIFT F10
If you are in a category with groups (F2-F5), SHIFT F10 resets the current group. If
you are in a category without groups (F1, F7-F10), SHIFT F10 resets the entire
category.
ALT F10
Resets all options in current category to default settings.
CTRL Escape
Exit configuration, saving changes (Permanent).
ALT Escape
Exit configuration, without saving changes.
))
Note: If you experience some character loss during setup, you may press the CTRL-(Keypad Minus) key to slow character
transmission. To speed up character transmission, press the CTRL-(Keypad Plus) key.
))
Note: After 5 minutes of inactivity (no key presses) the decoder will exit setup mode and save all changes.