Operation Manual

Manual UTP (Ethernet) connection ICU charging station

You are in possession of an intelligent ICU charging

station that can communicate with a back office system

through an internet cable. Your charging station is

configured to connect to a network directly. Through the

back office system of the charging station, it is possible to

view the energy consumption and offer remote control.

Which cable is required to connect the charging station?

A UTP cable of minimally CAT5 is needed to connect the charging station to

the Internet. This cable is suitable for speeds up to 100Mbps.

Installation

1. Connect the UTP cable to your router;

2. Turn off the power of the charging station by putting the main switch

to the zero (0) position;

3. Connect the UTP cable to the Communication Unit of the charging

station. See Figure 2 for the ICU Compact and Figure 3 for the ICU

Eve;

Image 2: ICU Compact

UTP port

Figure 1:

UTP cable

PAGE 1
Manual UTP (Ethernet) connection ICU charging station You are in possession of an intelligent ICU charging station that can communicate with a back office system through an internet cable. Your charging station is configured to connect to a network directly. Through the back office system of the charging station, it is possible to view the energy consumption and offer remote control.
PAGE 2
UTP port Image 3: ICU EVe 4. 5. Turn on the power of the charging station by putting the main switch to the 1 position; Register your ICU EZ account. Registering your ICU EZ account Step 1 Go to www.icu-charging-stations.com/ez-english. Fill out the digital form and click 'Send'. Step 2 ICU will process the form and activate your account. Your login details will be sent to you as soon as possible. Step 3 You can login to the website www.icu-ez.com with your received account information.
PAGE 3
Figure 4 Is your charging station ON and is the UTP cable connected properly? Then proceed to the next step. Step 5 In order for your charging station to communicate with ICU EZ through a wired UTP ethernet connection, your network setting should be adjusted if these are additionally secured. Below you will find the necessary information to allow access through your network.  IP address ICU EZ: 93.191.128.6;  Port: 9090;  Inbound – Outbound.