ICS-85 L85 A2 ICS-86 L86 A2 ICS-87 L85 A2 CARBINE L85/L86 aeg series
3. Component names ICS-85 L85 A2 Carry handle Upper handguard Front sight Safe pin Charging handle Handguard move button Butt plate Flashhider A2 handguard Bolt catch Trigger Grip Rear sling clip Magazine Model Pistol grip L85 A2 L85 A2 L85 aeg series ICS-86 L86 A2 Upper handguard Carry handle Butt plate Weight Length 3652 g 786.
4. Battery fitting method 1 ICS-85 L85 A2 2 3 Insert battery and connect wire L85 aeg series Open upper handguard, press move button, and pull handguard. Assemble handguard and manage wire, close upper handguard ICS-86 L86 A2 1 2 Open upper handguard. 3 To pull open handguard. Move sideward and insert battery, than close it.
5. Gear box Reassembly is reverse of disassemblys procedures ICS-85 L85 A2 1 2 3 Front pin L85 aeg series Move rear pin and disassemble butt plate Bipod Move front pin and disassemble main body. Turn upside down to avoid gearbox dropping, release motor wire and take off gear box. ICS-86 L86 A2 Close bipod Push bipod plate and close bipod put legs on plate Open bipod Pull bipod plate, turn out legs and off hand.
6. Fine adjustment of gear engagement. Disassemble carry handle * Don't adjust yourself. 3 2 1 L85 aeg series After release butt plate, use screw driver to adjust, when finish adjusting, close the plate. Release 2 pins on left side, push forward and take off handle. Hop Up Hop Up adjustment Move charging to end and pull up the charging pin, after adjust hop up, pull back charging it will go forward. Decrease Hop adjustment Best trajectory Increase Hop adjustment Adjustment procedure: 1.
7. Bear sight and front sight adjustments Selector lever and safety setting Full automatic DOWN UP Semi automatic L85 aeg series Use screw driver to press down button, adjust sight high or low. Magazine attachment Safe convert load BBs Magazine loading and unloading F Turn to F, pull trigger can shoot. F S Open the cover to load BBs. Please use ICS 6mm caliber BBs for optimum Performance. Turn to S, pull trigger can't shoot. S To charge BB feed spring, please wind magazine.
8. Spring adjustment Rear sight and adjustments : Forward Far destination :move sight forward : Backward Close destination :move sight backward Release box pin, 3 position spring compress. L85 aeg series Right Left Clockwise Counter clockwise Middle hole for median power How to use a cleaning rod Front hole for low power Rear hole for high power Insert cleaning rod, turn left and right, move back and forward.
9.
10.
