User Instructions

ManualsBrandsICS Innovation ManualsElectronicsWireless Charger

Table Of Contents

15-25mm

Mounting hole for

Wireless charger W-1

64 mm diameter

Cable hole

25 mm diameter

Wireless charger W-1

DC power

supply 5V 2,5A

Please twist this

handle in CCW

direction till you feel

resistance

USB HUB TYPE A/LI

500 mm

1000 mm

Air jack connector

should be disconnected

before mounting

Round cable

3,6 mm

Recommended

top panel

thickness

DUAL CHARGING TECHNOLOGY

Step 1

Patent pending

MOUNTING INSTRUCTION "UNDER FURNITURE TOP"

WIRELESS CHARGER W-1 + USB-EC-A2FS-B/LI

PAGE-1

WIRELESS CHARGER W-1

Summary of content (4 pages)

PAGE 1
PAGE-1 WIRELESS CHARGER W-1 DUAL CHARGING TECHNOLOGY MOUNTING INSTRUCTION "UNDER FURNITURE TOP" WIRELESS CHARGER W-1 + USB-EC-A2FS-B/LI Recommended top panel thickness 15-25mm Mounting hole for Wireless charger W-1 64 mm diameter Cable hole 25 mm diameter Wireless charger W-1 Please twist this handle in CCW direction till you feel resistance USB HUB TYPE A/LI 500 mm Round cable 3,6 mm 1000 mm Air jack connector should be disconnected before mounting DC power supply 5V 2,5A Step 1 Patent pending
PAGE 2
WIRELESS CHARGER W-1 PAGE-2 Install W-1 wireless charging device into prepared hole If wireless charger device fits properly to the hole and you feel that device can not be pushed deeper please twist this part in CW direction to lock Connect air jack connector after mounting in furniture Step 2 Step 3 Patent pending
PAGE 3
WIRELESS CHARGER W-1 PAGE-3 Locker should look like picture shown when in the closed position Light description: -One blink at power on -Constant lighting when Wireless charger is charging phone. -The green light disappears when phone is charged fully.
PAGE 4
1. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment 2. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.