Installation Manual
Table Of Contents
iv 
Important Safeguards and Warnings 
Safety Measures 
1. Qualified Engineer Needed  
  The installation engineer or maintenance engineer shall have corresponding CCTV system 
installation certificate or maintenance qualification certificate.  
  The installation engineer or maintenance engineer shall have qualification certificate for work 
at height.  
  The installation engineer or maintenance engineer shall have the basic knowledge and 
operation technique for low-voltage cable layout and low-voltage electronic cable connection. 
  Please read the installation manual carefully and keep it well for future reference, 
  We are not liable for any problems caused by unauthorized modifications or attempted repair. 
2. Lifting Appliance Requirement  
  Please select the proper speed dome installation mode and use the lifting appliances at the 
safety environment. 
  The lifting appliances shall have the enough capacity to reach the installation height. 
  The lifting appliances shall have safe performance.  
The precaution measures include two types: Warning and Note. 
  Warning: It is to alert you there is an optional risk of death or series injury! 
  Note: It is to alert you there is an optional risk of damage or property loss! 
Warning 
1.  All installation and operation here should conform to your local electrical safety codes. We 
assume no liability or responsibility for all the fires or electrical shock caused by improper 
handling or installation.  
2.  Be sure to use all the accessories (such as power adapter) recommended by manufacturer. 
3.  Do not connect several speed domes to one power adapter. It may result in overheat or fire 
if it exceeds the rated load.  
4.  Avoid aiming the lens at the strong radiation source directly (such as sun, laser, molten steel 
etc); in case it may cause unrecoverable damage to the thermal imaging detector. What’s 
worse, it may cause severe damage to the detector.  
5.  Avoid oil stain and kinds of chemicals tarnishing and damaging the lens surface. 
6.  Store the device in a cool and dry place where there is ventilation but no intense 










