Installation Manual
Table Of Contents
- 1 Installation Preparation
- 2 Install IR Intelligent Speed Dome
- 3 Wall-mounted Bracket Installation
- 4 APPENDIX Ⅰ LIGHTNING PROOF AND SURGE PROTECTION
- 5 APPENDIX Ⅱ ABOUT RS485 BUS
- 6 APPENDIX Ⅲ THE RELATIONSHIP BETWEEN AC 24V CABLE DIAMETER AND TRANSMISSION DISTANCE
- 7 APPENDIX Ⅳ WIRE GAUGE REFERENCE SHEET
15
Figure 3-3
Step 2
Insert the expansion bolts into the holes you just dug.
Step 3
Use four hex nuts and flat gasket to twist the wall-mounted bracket into the expansion bolts.
Step 4
Install the speed dome on the wall-mounted bracket, which is shown in Figure 3-4. Please refer
to “2.4.2 Install Speed Dome” for the installation modes of the device.