Installation Manual
Table Of Contents
- 1 Installation Preparation
- 2 Install IR Intelligent Speed Dome
- 3 Wall-mounted Bracket Installation
- 4 APPENDIX Ⅰ LIGHTNING PROOF AND SURGE PROTECTION
- 5 APPENDIX Ⅱ ABOUT RS485 BUS
- 6 APPENDIX Ⅲ THE RELATIONSHIP BETWEEN AC 24V CABLE DIAMETER AND TRANSMISSION DISTANCE
- 7 APPENDIX Ⅳ WIRE GAUGE REFERENCE SHEET
10
Figure 2-10
Step 2
Connect Speed dome cable and wall cable well, make sure both are waterproof. Please refer to
“2.4.1 Speed Dome Cable” for more details about cable connection.
Step 3
Align the flange edge with that of the bracket; push the speed dome into the bracket, twist three
stainless screws into the corresponding screw holes of the flange, and then use inner hex tool to
fix three stainless screws, which is shown in Figure 2-11.