Installation Manual
Table Of Contents
- 1 Installation Preparation
- 2 Install IR Intelligent Speed Dome
- 3 Wall-mounted Bracket Installation
- 4 APPENDIX Ⅰ LIGHTNING PROOF AND SURGE PROTECTION
- 5 APPENDIX Ⅱ ABOUT RS485 BUS
- 6 APPENDIX Ⅲ THE RELATIONSHIP BETWEEN AC 24V CABLE DIAMETER AND TRANSMISSION DISTANCE
- 7 APPENDIX Ⅳ WIRE GAUGE REFERENCE SHEET
7
2.4.2.1 Install Device with Quick Mounting Connector
Step 1
Fix the quick mounting connector on the bracket, and pull out the wall cable from the quick
mounting connector.
Step 2
Fix one side of the safety rope on the speed dome and the other side on the quick mounting
connector.
Step 3
Align the flange edge with that of the quick mounting connector; push the speed dome into the
quick mounting connector, which is shown in Figure 2-7.
Figure 2-7
Step 4
Connect Speed dome cable and wall cable, make sure both are waterproof. Please refer to
“2.4.1 Speed Dome Cable” for more details about cable connection.
Step 5
Twist three stainless screws into the corresponding screw holes of flange, use inner hex tool to
tighten three stainless screws, which is shown in Figure 2-8.