User Manual

27
LASER SETTING RULE: ：ZOOM PRIORITY
ANGLE ：35
INTENSITY ：100
BACK EXIT
 WIPER MODE: It is to set the wiper mode. It includes two modes: manual and schedule, click “left”,
“right” button to set.
 START TIME: It is to set the wiper start time, click “left”, “right” button to set.
Note: It is valid only when the wiper mode is set as schedule mode.
 END TIME: it is to set the wiper end time, click “left”, “right” button to set.
Note: it is valid only when the wiper mode is set as schedule mode.
 INTERVAL: it is to set the interval between the two actions for the wiper, click “left”, “right” button to set.
 WIPER CONTROL: It is to set the wiper action, it can set start, stop, once. Click “left’, “right” button to
set.
Note: It is valid only when the wiper mode is set as manual mode.
 SAVE: It is to save the setting.
 BACK: Go back to the previous menu.
 EXIT: Log out the system menu.
4.4.6 Laser Setting
Move the cursor to the LASER SETTING button and then click confirm button to set.
 LASER SETTING RULE: It is to set the laser setting rule, there are two options: zoom priority and
manual.
Click “left”, “right” button to set.
 ANGLE: It is to set the laser angle, click “left”, “right” button to set.
Note: It is valid only when laser setting rule is set as manual mode.
 INTENSITY: it is to set the laser intensity, click “left’, “right” button to set.
Note: It is valid only when the laser setting rule is set as manual mode.
 BACK: Go back to the previous menu.
 EXIT: Log out the system menu.
4.5 Abnormity Handling
If users hope to restore the speed dome to factory default, please enter the main menu of the speed dome “
SYSTEM INFORMATION > FACTORY DEFAULT”, move cursor to FACTORY DEFAULT and click confirm
button. The speed dome will reboot and all the setups restore to factory default setup.