Quick Start Guide
MARGIN
GUIDES
Stay within the yellow 
box. Do not let text go 
beyond, instead move 
to the next column or 
start a new page. 
9 | www.icrealtime.com
Device does not 
operate properly/ lost 
password.
Please refer to section 2B for factory reset 
process. Cam will need to be Initialized after 
factory reset.
The water leakage.
The front or rear cap if damaged or removed 
can result in water leakage. The glass dome 
may also have been compromised from 
heavy strikes or heavy pressure. The 
waterproof plug of the rear cap may also 
have loosened.
IR video is poor/ does 
not turn on.
Verify the camera is supplied with the 
recommended amount of power. You may 
need to test voltage/ amperage of the 
camera while under load. Enough visible 
light at the location can also cause IRs to not 
switch on.
I can not upgrade the 
device via network.
Contact technical support to request 
firmware. 
I cannot login to the 
client-end or the 
WEB.
If the Camera HTTP port is changed, you will 
need to specify the port number after the IP. 
(ex: http://192.168.1.108:8080) Ensure the 
correct login credentials are being used. The 
Smart ICRSS software will use the TCP port. 
Make sure you input the correct TCP port 
number.
The account is locked
Reboot the camera to clear lock out. Verify 
the login to make sure it is correct.
5A. FAQ
P2P status is “not 
connected/ offline”
You may need to set device IP to DHCP. 
After acquiring a different IP address, verify 
P2P status and set camera back to static IP 
if successful.
Camera does not 
show up on local 
network.
Verify the camera is supplied with the 
recommended power supply. Change 
network cable or use short patch cable to 
troubleshoot.
5B. APPENDIX TOXIC OR HAZARDOUS MATERIALS OR ELEMENTS
Component Name  Pb Hg Cd Cr VI PBB PBDE
Circuit Board 
Component
• • • • • •
Device Case
• • • • • •
Wire and Cable
• • • • • •
Packing Components 
• • • • • •
Accessories 
• • • • • •
O: Indicates that the concentration of the hazardous substance in all 
homogeneous materials in the parts is below the relevant threshold 
of the SJ/T11363-2006 standard.










