Quick Start Guide

2A. INSTALLATION STEPS (IPEL-F12 series)

Please follow the steps listed below to install the device.

MARGIN

GUIDES

Stay within the yellow

box. Do not let text go

beyond, instead move

to the next column or

start a new page.

3 | www.icrealtime.com

Figure 2-1

Step 1 Use the included position map and place it on the mounting

surface. After rotating the position map accordingly, drill the

mounting and cable exit holes in accordance to the map. See Figure

2-1.

Step 3 Adjust the camera mounting plate, and pull the cable through the

exit hole. Match the ”TOP” direction of the camera with that from the

installation template. Align the 3 mounting plate holes with the plastic

anchors from Step 2. Install the ST3.0 screws through the mounting

plate holes, and into the plastic anchors.

Figure 2-2

Figure 2-3

Figure 2-4

Step 2 install the included plastic anchor screws. See Figure 2-2.

Step 4 Take the dome cover and align it with the base plate that is now

ﬁxed to the installation surface. Re-install the 3 hex screws, securing

the dome back in place.