Quick Start Guide

2A. INSTALLATION STEPS
Important: Before the installation, please make sure the installation
environments can at least support 3x weight of the camera.
Step 1 Remove the installation position map from the accessories bag
and paste it on the installation surface according to your monitoring
area requirements. Use the wrench in the accessories bag to
unscrew the three torx head screws on the dome cover and then
remove the dome cover. See Figure 2-1.
MARGIN
GUIDES
Stay within the yellow
box. Do not let text go
beyond, instead move
to the next column or
start a new page.
3 | www.icrealtime.com
Figure 2-1
Step 2 Remove the installation position map from the accessories bag
and paste it on the installation surface according to your monitoring
area requirements.
Step 3 Find “cross”signs on the map, and drill three plastic expansion
bolts holes on the installation surface and then insert three expansion
bolts into the holes. Secure these three bolts firmly. See Figure 2-2.
Step 4 Adjust the dome body to the proper position and then pull cable
through the exit hole on the installation surface. Align the three screw
holes in the dome body with the three plastic expansion bolt holes in the
installation position. Put the three installation screws into the three
plastic expansion bolts and secure them firmly.
Step 5 To adjust the lens angle, see Figure 2-3. To adjust focal length
(if applicable), see Figure 2-4.
Figure 2-4Figure 2-2
Figure 2-3