Quick Start Guide

2A. INSTALLATION STEPS
● Please make sure the installation surface can support at least
3X weight of the camera and the bracket.
MARGIN
GUIDES
Stay within the yellow
box. Do not let text go
beyond, instead move
to the next column or
start a new page.
3 | www.icrealtime.com
Step 1 Place the installation position map on the installation surface
(wall or ceiling) then drill holes for the expansion bolts according to
the installation position map. See Figure 2-1. Drill a hole for the cable
exit if you are installing the cables through the installation surface.
Step 2 install the expansion bolts into the predrilled holes.
Step 3 Align the screw holes of the camera base with the mounting
hole sites then install the mounting screws into the expansion bolts.
See Figure 2-2.
Step 4 Thread the base screws through the mounting holes in the
base of the camera.
Figure 2-2
Figure 2-1