Installation guide

Non-Communicating Indoor Unit with
Figure 14 Observer Communicating Wall Control
Wall
Control
NAXA00101DB
Green
Red ,_
White "C_
Yellow ,_
"C_'
I- q GD
Non-Communicating
Indoor
Note: This installation requires the daugh-
ter board accessory, NAXA00101DB. _o
Note: This installation does not allow for OAT
communicating feature functionality.
Communicating
Outdoor
----A--
____A__r-
L'O
OAT
Sensor
Final Checks
IMPORTANT: Before leaving job, be sure to do the following:
1. Ensure that all wiring is routed away from tubing and sheet
metal edges to prevent rub-- through or wire pinching.
2. Ensure that all wiring and tubing is secure in unit before
adding panels and covers. Securely fasten all panels and
covers.
3. Tighten service valve stem caps to 1/12--turn past finger
tight.
4. Leave Owner's Manual with owner. Explain system
operation and periodic maintenance requirements outlined
in manual.
CARE AND MAINTENANCE
For continuing high performance and to maintain warranty
coverage, periodic maintenance must be performed on this
equipment. Frequency of maintenance may vary depending
upon geographic areas, such as coastal applications. See
Owner's Manual for information.
14 specificationssubjectto change without notice. 421 01 1702 04