Manual

Thermostat Connections
The location of the thermostat has an important effect on the op-
eration ofthe unit. See the thermostat instructions for proper con-
nection. See FIGURE 5 for Low Voltage Wire Harness
Connections
Field Installed Equipment
Wiring to be done in the field between the unit and other devices,
or between separate devices which are field installed and located,
MUST NOT exceed the temperature limitations for type T wire
and MUST be installed according to the manufacturer's instruc-
tions for the devices.
FIGURE 5 I HarnessElectr°niCconnectionTherm°statDiagramL°WVoltage Wi ring
Typical Thermostat Subbase
[c] [?] [R,] _ _,]
I I I I I
I I I I I
_ _ _ _ (when used)
I I I I /
i i i i A
I I I I I
I
[Blue] [Green] [F_ed] [Yellow] [White] _[
Corn Fan 24V Comp Elect.
(when Cool Heat
used) Acces.
Unit Low Voltage Wiring Harness.
FIGURE 6 I Typical Connections at Unit
USE COPPER CONDUCTORS ONLY
2g8/23gV 60HZ 3PH
FIGURE 7 Control Box Configuration
Outdoor Fan f._ '_-_ t
copao,tor\ _0-:__"_
c;: o;en,
Bl°wer Relay °r Sequence L __2_"_///_
Transformer%___ ___/__/_
Anti-Cycle Time J_.X_ _ I_:_"_:;_ j_f /'_" Control Box
Volt Wire Entrance
_owvo,twireEntrance_ _.__ __i_i
Wire
426 01 1005 O0
5