Manual

ManualsBrandsICP ManualsFurnaceOfficial ICP furnace

HOTSURFACEIGNITION

Fire or explosion hazard.

Information in this manual MUST be

followed exactly.

Failure to follow the information in

this manual exactly could result in

death, bodily injury and/or property

damage.

-- Do not store or use gasoline or other

flammable vapors and liquids in the vi-

cinity of this or any other appliance.

-- WHATTO DO IF YOU SMELL GAS

• Do NOT tryto lightany appliance.

• Do NOT touchany electrical switch; do NOT

use any phone in your building.

• Immediately evacuate the building and call

your gas supplier from a phone outside the

building. Follow the gas supplier's instruc-

tions.

• If you cannot reach your gas supplier,call the

fire department.

-- Installationandservicemustbe performedbya

qualified installer, service agency or the gas

supplier.

25-21-60

Manufactured by:

International Comfort Products Corporation (USA)

Lewisburg, TN USA 37091

Printed in U.S.A. LP1 Part No. 441 02 2002 O0 (3/2/2000)

Summary of content (8 pages)

PAGE 1
HOT SURFACE IGNITION Fire or explosion hazard. Information in this manual followed exactly. MUST be Failure to follow the information in this manual exactly could result in death, bodily injury and/or property damage. -- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. -- WHAT TO DO IF YOU SMELL GAS • Do NOT tryto lightany appliance. • Do NOT touchany electrical switch; do NOT use any phone in your building.
PAGE 2
Fan Assisted Combustion Gas Furnace User's Information Manual Contents Danger, Warningand Caution ................ Safety Rules ............................. Combustion Air (Yoursafety) ................ 2 3 3 Operating Your Unit ........................ Unit Maintenance ......................... 5 6 Danger,Warningand Caution The signal words DANGER, WARNING and CAUTION are used to identify levels of hazard seriousness.
PAGE 3
User's Information Manual Fan Assisted Combustion Gas Furnace 5. Read this manual and follow its instructions and adhere to all Cautions and Warnings in the manual and on the unit. Consult a qualified service technician for installation, adjustment and maintenance. Checks" or call a service technician. If you add weather stripping, storm windows, insulation, an additional fuel burning appliance, or remodel the structure, a combustion air check MUST be accomplished after the addition.
PAGE 4
Fan Assisted Combustion Gas Furnace User's Information Manual New materials and methods are being used in construction and remodeling which result in lower energy costs for heating and cooling. It may also mean your appliances may not be getting enough air for combustion and ventilation of flue gases. The use of exhaust fans, fireplaces, clothes dryers, and other appliances consume air or vent it outside.
PAGE 5
User's Information Manual Figure 2 I Component I Fan Assisted Combustion Gas Furnace Locations Vent Pipe Combustion Blower er Manual Gas Pressure Switch (2 switches on some models) Circulating Gas Blower Main Burners Circulating Blower Motor Control Board 25-22-96 5. 6. OperatingYourUnit 7. Slide the gas control switch to OFF. See Figure 3. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow the safety information on the cover of this manual.
PAGE 6
Fan Assisted Combustion Gas Furnace User's Information Manual System Retries The ignition system tries to relight the burners whenever built-in flame sensor detects no flame. the TurningOff The unit Set the thermostat to the lowest setting or set System Switch to OFF if equipped. Select Should overheating occur or the gas supply fail to shut off, shut off the manual gas valve to the unit before shutting off the electrical supply. Extended Shutdown L P Model Units If your LP.
PAGE 7
User's Information Manual Fan Assisted Combustion Gas Furnace Recommended Table 1 Unit Size Heating Input 1000 x Btu h Filter Sizes Nominal Air Flow Cubic Feet per Minute (CFM) 40 - 50 800-900 40 - 50, 75, and 1O0 900-1100 1100-1300 40 - 50, 75, and 1O0 75,100, and 125 1O0 and 125 1300-1500 125 150 1900-2100 2300-2500 1500-1700 Replacement Filters Recommended Filter Sizes Sq, In.
PAGE 8
Fan Assisted Combustion Gas Furnace User's Information Manual Lubrication The circulating blower motor and combustion require lubrication. • Stable and blue flames. Dust may cause orange tips or wisps of yellow, but flames must not have solid yellow tips. • Flames extending changer. • Flames do not touch sides of heat exchanger.