Manual

ManualsBrandsICP ManualsFurnaceOfficial ICP 80+ single-stage gas furnace

Condensing Gas urnaces

90+ Four Position Furnaces

N9MP1, N9MP2, *9MPD, *9MPT & *9MPV

Non-Condensing Gas urnaces

80+ Four Position Furnaces

N8MPN/L, *8MPN/L, *8MPT & *8MPV

*8DNL (Downflow only)

Installer: Affix these instructions

on or adjacent to the furnace.

Consumer: Retain these

instructions for future reference.

FIRE OR EXPLOSION HAZARD.

Failure to follow safety warnings

exactly could result in death, serious

injury and/or property damage.

-- Do not store or use gasoline or other

flammable vapors and liquids in the

vicinity of this or any other appliance.

-- WHAT TO DO IF YOU SMELL GAS

• Do NOT try to light any appliance.

° Do NOT touch any electrical switch; do

NOT use any phone in your building.

° Leave the building immediately

° Immediately call your gas supplier from a

neighbor's phone. Follow the gas supplier's

instructions.

° If you cannot reach your gas supplier, call

the fire department.

-- Installation and service must be performed by

a qualified installer, service agency or the gas

supplier.

International Comfort Products, LLC

Lewisburg, TN 37097

PrintedinU.S.A. (06/28/2004) 441 02 2010 04

Summary of content (16 pages)

PAGE 1
Condensing Gas urnaces 90+ Four Position Furnaces N9MP1, N9MP2, *9MPD, *9MPT & *9MPV Non-Condensing Gas urnaces 80+ Four Position Furnaces N8MPN/L, *8MPN/L, *8MPT & *8MPV *8DNL (Downflow only) FIRE OR EXPLOSION HAZARD. Failure to follow safety warnings exactly could result in death, serious injury and/or property damage. -- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. -- WHAT TO DO IF YOU SMELL GAS • Do NOT try to light any appliance.
PAGE 2
User's Information Manual Contents Danger, Warning and Caution ................ Safety Rules ............................. 2 3 Combustion Air (Your Safety) ................ Indoor Humidity (Your Comfort) .............. 4 5 About Your Furnace ....................... Operating Your Furnace .................... Furnace Maintenance ...................... Warranty ............................... 5 8 9 15 Danger,Warning and Caution Recognize safety information.
PAGE 3
User's Information Manual 4. Never block or any ducts provided DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE HAZARD Consult a qualified installation, adjustment service agency and maintenance. 6. Check the life of the could water heaters, furnaces, gas-fired fireplaces, wood fireplaces, and several other items. Carbon monoxide can cause serious bodily injury a nd/or death.
PAGE 4
User's Information Manual c. (Upflow or downflow installations with duct connection at bottom only.) The physical support of the furnace is Pilot Burner sound without sagging, cracks, gaps, etc., around the base so as to provide an air seal between the support and the base. d. There should furnace. be no obvious signs of deterioration Flame Sensor Pilot of the e. Check that the pilot and burner flames are in good adjustment.
PAGE 5
User's Information Manual If draft hood spillage CARBON MONOXIDE POISONING HAZARD. Carbon monoxide poisoning could result in death from asphyxiation or serious bodily injury. If you experience headaches, nausea, or dizziness, carbon monoxide may be present. Leave the house immediately supplier. Combustion and call your gas 1. Check for plugged vent connectors stoppage and test again. 2. Ifyou have a fireplace, place and then check 3.
PAGE 6
User's Information Manual CirculatingAir Blower less a call for cooling is initiated. Blower speed will correspond to the mode of operation of the furnace. If the Fan Switch is posi- The blower circulates room air through the furnace, air ducts, and into the rooms of the structure. The blower can be set at the ther- tioned mostat blower In addition for automatic or manual operation. operates continuously.
PAGE 7
User's Information Manual Component Locations for 80+ Furnaces (4-Position) Venter get Pressure Switch (2 switches on some models) Manual Shutoff Equipment Valve Blower Furnace Control Main Gas Valve "Drip Leg Circulating Motor Fan/Delay Control Rating Plate 25-24-30V Representative Component Locations Blower for 80+ Furnaces drawing only,somemodelsmayvaryinappearance.
PAGE 8
User's Information Manual Pressure Switch The furnace shut down switches Should overheating occur or the gas control off, shut off the manual equipment shutoff is equipped the furnace with one or more pressure switches to under various flue conditions. The are connected to the furnace by factory supplied tubing. nace panels personal combustion in death electrical supply. Set thermostat to lowest temperature setting or set thermostat System Select Switch to OFF, if so equipped. 2.
PAGE 9
User's Information Manual L P Model Furnaces 1. Disconnect the 1/2" I.D. rubber hose from the vent drain fitting (or tee) that is located downstream of the combustion blower. Insert a funnel into the hose and pour four (4) ounces of sanitary type (RV) antifreeze into the condensate trap. Reconnect the 1/2" I.D. rubber hose to the stub FIRE OR EXPLOSION HAZARD on the vent drain Failure to detect and stop gas leak could death, bodily injury, or property damage. result in 2.
PAGE 10
User's Information Manual 3. Slide 4. Inspect the filter(s) filter is aluminum RISK OF REDUCED FURNACE LIFE the filter out of the filter rack. See Figure coating Use of excessively dirty and/or restrictive air filters may increase furnace operating temperatures and shorten the life of the furnace. Filters specified for the furnace are rated at a maximum of 600 FPM air velocity and sized for the furnace's airflow rate.
PAGE 11
User's Information Manual External Filter Rack A plastic end cap is inserted in the filter rack after the filter is installed. The end cap keeps air from escaping around the open end of the filter rack. See Figure 8 for removal of filter. Filter racks attached to the furnace slides out one end for removal. 1. Turn OFF electric 2. Remove are made so the filter simply Turn OFF power to furnace. 2. Remove 3. Reach up above right side of blower, of rack at top of furnace. 4.
PAGE 12
User's Information Manual 441 02 2010 04
PAGE 13
User's Information Manual 441 02 2010 04
PAGE 14
User's Information Manual 441 02 2010 04
PAGE 15
INTERNATIONAL COMFORT PRODUCTS LIMITED WARRANTY CERTIFICATE For Cooling SAVE THIS province CERTIFICATE, It gives you specific legal rights, & Heating and you Products may also have other rights which may vary from state to state and to province. If your unit needs servicing, contact a qualified dealer or qualified service agency of your choice. When requesting service, please have the model and serial number from each unit in your heating and/or cooling system readily available.
PAGE 16
ADDITIONAL Tile Additional Terms Warranty CENTRAL for tile components coverage is limited TERMS FOR RESIDENTIAL listed below to parts that APPLICATIONS are in addition to, and subject fail due to defect in materials to, the General or workmanship ONLY Terms on tile reverse daring the specified side of this page. term. GAS & OIL FURNACE HEAT EXCHANGERS* Gas Model Series: C9MPV, H9MPV, T9MPV, C9MPT, H9MPT, T9MPT, C9MPD, H9MPD, T9MP: Limited Lifetime Warranty on heat exchangers.