Installation guide

Figure 1 Clearances and Unit Dimensions

,s .,_

- -_ -_ ,,.," J "

REQUIRED CLEARANCES (inches)

All Sides 0

All

Models Serviceability from the front 30

From Supply Duct 0

_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!i_!

Size

Model

(tons) A B

AHX32400 2 171/2 21

AHX33600 3 171/2 21

AHX34800 4 211/2 25

AHX36000 5 211/2 25

all dimensions inches Coil Ship.

Weight

C D E F G Liquid Suct. Type fibs)

15 171/2 16 12b/8 403/4 3/8 3/4 "A" 144

15 17_/2 16 12_/8 403/4 3/8 3/4 "A" 144

191/4 221/4 19b/8 171/4 493/4 3/8 //8 "A" 192

INTRODUCTION

Models AHX3 are designed for an upflow vertical applica-

tions.

All models are available for system sizes 2 - 5 tons

(24,000 - 60,000 BTUH) nominal cooling capacity.

All models have a factory installed 15% bleed port TXV

designed for use with R-22 refrigerant. AHX3 are for

R-22 refrigerant ONLY. Use only with outdoor units de-

signed for R-22

An accessory R410A TXV kit is available through the dis-

tributor. AHTXV153 (2 - 3 ton) or AHTXV355 (4 - 5 ton)

LOCATION

Select the best position which suits the installation site

conditions. The location should provide adequate struc-

tural support, space in the front of the unit for service ac-

cess, clearance for return air and supply duct

connections, space for refrigerant piping connections and

condensate drain line connections. See Clearances in

Figure 1.

If the unit is located in an area of high humidity, nuisance

sweating of casing may occur. On these installations a

2 Specilic.ti........ bjectto_h.ng_.itho.t.oti_ 496 01 2100 03