Owners manual

TPD/VPD Series HMI Device User Manual

 Follow the procedure described below:

Step 1: Attach a power supply to the TouchPAD device. Refer to Section 3.3 “Supply Power to the

TouchPAD” for more details.

Step 2: Connect the TouchPAD device to the Host PC using a CA-USB10 cable.

Step 3: Power off the TouchPAD device and use a flat-head screwdriver to set the Rotary Switch on

the TouchPAD device to “Update AP” mode (position 9). Note that the default configuration is “Run”

mode (position 0).