Owners manual
TPD/VPD Series HMI Device User Manual
Copyright © 2015 ICP DAS Co., Ltd. All Rights Reserved. Page: 28
2.1.7 VPD-132/132N/133/133N Series Models
1.
LED Indicator
2.
3.5” TFT LCD with Touch Panel
3.
Rubber Keypad (for VPD-132/133 only)
4.
PoE and Ethernet RJ-45 Jack (for VPD-133/133N only)
The TouchPAD device is equipped with an RJ-45 jack that is used as the 10/100
Base-TX Ethernet port and features networking capabilities. When an Ethernet link is
detected and an Ethernet packet is received, the Act LED (Green) indicator will be
illuminated. When power is supplied via PoE (Power-over-Ethernet), the PoE LED
(Orange) indicator will be illuminated.
5.
Power/GND/RS-232/RS-485 Connector
The TouchPAD device is equipped with a removable terminal block connector is
designed for easy and robust wiring. For more detailed information regarding the pin
assignments, refer to Section 2.2.5 VPD-132/133 Series Models.
6.
Rotary Switch (0 ~ 9)
The Rotary Switch is used to set the configuration modes, as follows:
0. Run: This mode is used to run the application. (There is only one application on a
TouchPAD device.)
1. Update OS: This mode is used to update operating system of TouchPAD device.
9. Update AP: This mode is used to download an application to TouchPAD device.
(There is only one application on a TouchPAD device.)