User Manual

Version 2.2 March 2005 iControl Confidential page 45
Appendix A Battery Maintenance
iControl box
No battery maintenance is required as it does not contain a battery.
iControl Wired Camera
No battery maintenance is required as it does not contain a battery.
iControl Door/Window Sensor
The Sensor (the larger module of the two—sensor and magnet) requires a 3 VDC battery
and is designed for long battery life. To change the battery, follow these steps:
1 Remove the cover from the base plate by using a pen knife or similar tool to pry
them apart.
2 Slide out the battery and replace it with a new one.
iControl Lamp Module
No battery maintenance is required as it does not contain a battery.
iControl Motion Sensor
The motion sensor uses 2 AA batteries and is designed for long battery life. To change
the battery, follow these steps:
1 Open the Motion Sensor via the sensor body button and pull the sensor body away
from the mounting plate. Most of the motion sensor is now removed from the
mounting plate.
2 Press the tabs at the top and bottom locations and pull the sensor face plate off of
the sensor’s body.
3 Replace the batteries.
4 Replace the sensor body and face plate.
5 Go to the System tab to see if it shows the device.
iControl Keychain Remote
Your iControl Keychain Remote battery is designed to last several years. However if you
need to change the battery, follow these steps:
1 Turn over your Keychain Remote. Remove the screw on the back and then the back
cover.
2 Insert a 12 volt alkaline battery. Match the ‘+’ and ‘-‘ markings on the inside of the
battery compartment to the battery.
3 Reattach the cover.
4 Test the Keychain Remote.
Note: Please dispose of your battery in accordance to local regulations.