User Manual

Version 2.2 March 2005 iControl Confidential page 32
5 Using your Door/Window Sensor
Once you have installed a Door’/Window Sensor in your house and it appears in your
iControl Summary page, you only have to activate the sensor once to make it operational.
To do so, open and close the door or window once to tell your iControl box whether it is
initially open or closed. You do not need to make any other configuration changes or take
any other set up actions.
Check on your Door/Window Sensor
The following describes how to see the status of your Door/Window Sensor.
1 Navigate to the Summary page.
2 Go to the Status window. In the image shown below, the Door/Window Sensor is
named ‘office slider window front 1’ and its state is closed. This Door/Window
Sensor recognizes that the office slider window is closed.