User Manual

Version 2.2 March 2005 iControl Confidential page 22
3 On the Applications & Gaming page, in table entitled, Port Range, enter the
application name as ‘camera’.
4 Enter the Start port (obtained from the steps in the prior section, Setting up your
camera for video.) in the Start field. In this example it is 80. Enter the end port in
the End field as 80. The Start port and end port are the same in this example.
5 Select the protocol as ‘Both’ in the Protocol field.
6 Enter the IP Address obtained from the steps in the prior section, Setting up your
camera for video, in the IP Address field.
7 Check the check box under the heading, Enable.