User Manual

v.1.2

Using the Audio Mixer:

1. Launch iConfig. If you have other iConnectivity interfaces connected, select the

iConnectAUDIO4

in the Device Selection dialog.

2. Select the Audio Mixer tab. Mix A, the first of the available mixes in the Sub

Mix/Bussing section, should be selected. The mixer should look like the following screen

capture:

3. Bring up the Analog Outputs 1 & 2 fader (they’re linked for stereo). You should now

see three sets of stereo meters moving in the Audio Mixer. If you select Analog Outs

1&2 in Signal Level mode in the Interactive Display, the LED meters on the hardware

will match the onscreen ones.