User Manual
Table Of Contents
- Introduction
- Quick Start
- Features
- In the Box
- System Requirements
- Safety Instructions and Precautions
- Hardware Connections
- Controls
- Getting Started
- Setting Up the Interface
- Setting the Output/Phones Level
- Setting Up Inputs
- Direct Monitoring
- Troubleshooting
- Reference: Audio Specifications
- Reference: Direct Monitoring States
- Contact iConnectivity
- Warranty
ConnectAUDIO
2/4
User Manual
Rear Panel
1. USB Device Port:Use the included USB cable to connect your interface to a PC or Mac device run-
ning your Digital Audio Workstation host software. An iOS device can be connected using the Apple
Lightning-to-USB 3 Camera Adaptor.
2. MIDI In/Out: Accepts 5-pin MIDI DIN connections for standard MIDI hardware. MIDI is transmitted
at the standard MIDI rate of 31.25 Kbps
3. Analog Output Jacks 1 – 2 :¼" balanced TRS outputs for connecting to powered monitors or a ste-
reo amplifier with attached speakers. Output levels are capable of reaching +12dBu. Exercise cau-
tion when setting output levels to avoid potentially overloading equipment in the downstream signal
path. Note:Do not connect +48V phantom power to the analog output jacks as this could damage
the output circuits.
4. Chassis Grounding Screw: Use this grounding screw if grounding issues occur when connecting
multiple electronic devices.
9