User Manual
Table Of Contents
- Introduction
- Quick Start
- Features
- In the Box
- System Requirements
- Safety Instructions and Precautions
- Hardware Connections
- Controls
- Getting Started
- Setting Up the Interface
- Setting the Output/Phones Level
- Setting Up Inputs
- Direct Monitoring
- Troubleshooting
- Reference: Audio Specifications
- Reference: Direct Monitoring States
- Contact iConnectivity
- Warranty
ConnectAUDIO
2/4
User Manual
With Direct selected on the Touch Panel Display, Direct Monitoring can be toggled to Stereo Mode by
touching the 48V/Inst button. The Direct LED indicator will change from green to red , indicating that DM is
now operating in stereo.
Figure 3: Toggling DM from Mono to Stereo Mode
Refer to the Direct Monitoring States reference section of this manual to view all the possible DM con-
figurations and their respective audio routing.
Working with Direct Monitoring: Adjusting the Input/USB Balance
With Direct Monitoring enabled, the meters on the Touch Panel Display toggle to show the respective
Input (left meter column) and USB (right meter column) levels. Moving the Rotary Control Dial adjusts the
balance between the two.
l Rotate the dial clockwise for more USB signal in the monitor mix
l Rotate the dial counter-clockwise for more Input signal in the monitor mix
Figure 4: Adjusting the Direct Monitoring balance
16