User Manual
Table Of Contents
- Introduction
- Quick Start
- Features
- In the Box
- System Requirements
- Safety Instructions and Precautions
- Hardware Connections
- Controls
- Getting Started
- Setting Up the Interface
- Setting the Output/Phones Level
- Setting Up Inputs
- Direct Monitoring
- Troubleshooting
- Reference: Audio Specifications
- Reference: Direct Monitoring States
- Contact iConnectivity
- Warranty
ConnectAUDIO
2/4
User Manual
Condenser Mics
1. Touch 48V/Inst once, to set +48V as the Input Mode. The LEDindicator will display green.
2. Touch 1, 2 or both to assign the +48V Input Mode to an input. The LED indicator light will dis-
play green for inputs to which +48V mode has been assigned.
Figure 2: Input Assign mode; 48V mode assigned to Input 1
Input Display States
l When you press the 48V/Inst button so that 48V is selected, inputs that display green are assigned
to 48V mode.
l When you press the 48V/Inst button so that Inst is selected, inputs that display green are assigned
to Inst mode.
Note:Input audio is temporarily muted when 48V power is turned ON or OFF. Allow a few moments for
the audio path to be re-enabled when engaging or dis-engaging the 48V function.
SettingInput Levels
With input modes assigned, follow these steps to set input levels:
1. Touch the In button once to enable Signal Level metering mode (green LED). Touch the In button
again to enable Gain Set metering mode (red LED). Refer to the Input Meter Modes section below
for more information about meter modes.
2. Touch 1 and/or 2 to select either or both inputs.
3. Turn the Rotary Control Dial to raise or lower the level of the selected inputs as you generate
source audio.
14