User Manual
Table Of Contents
- Introduction
- Quick Start
- Features
- In the Box
- System Requirements
- Safety Instructions and Precautions
- Hardware Connections
- Controls
- Getting Started
- Setting Up the Interface
- Setting the Output/Phones Level
- Setting Up Inputs
- Direct Monitoring
- Troubleshooting
- Reference: Audio Specifications
- Reference: Direct Monitoring States
- Contact iConnectivity
- Warranty
ConnectAUDIO
2/4
User Manual
5. Play the audio track in your DAW and move the Rotary Control Dial slowly until you begin to hear
audio in your speakers or headphones. Continue adjusting the dial to increase or decrease the level
as desired.
Out/Phones Meter Modes
There are two meter display modes. Pressing the Out or Phones buttons multiple times allows you to
toggle between:
l Signal Level mode, indicated by the green LED. The LED meters display VU (signal level) and will
react to the input signal in real time.
l Gain Set mode, indicated by the red LED. The LED meters display the gain setting and respond to
clockwise or counter-clockwise motion of the Rotary Control Dial.
Setting Up Inputs
Assigning Input Modes
With your interface connected, and your DAW open with the ConnectAUDIO
2/4
selected as the Input/Out-
put device, follow these steps to set up an audio input source and pass the audio signal to your DAWfrom
your ConnectAUDIO
2/4
:
Dynamic Mics, Instruments or Line-Level Sources
1. Touch 48V/Inst twice, to set Inst as the Input Mode. The indicator light will display red.
2. Touch 1, 2 or both to assign the Inst Input Mode to an input. The input indicator light will turn
green for inputs to which Inst mode has been assigned.
Figure 1: Input Assign mode; Inst mode assigned to Input 2
13