User Manual
Table Of Contents
- Introduction
- Quick Start
- Features
- In the Box
- System Requirements
- Safety Instructions and Precautions
- Hardware Connections
- Controls
- Getting Started
- Setting Up the Interface
- Setting the Output/Phones Level
- Setting Up Inputs
- Direct Monitoring
- Troubleshooting
- Reference: Audio Specifications
- Reference: Direct Monitoring States
- Contact iConnectivity
- Warranty
ConnectAUDIO
2/4
User Manual
Setting Up the Interface
1. Connect the interface to your PC, Mac, or iOS device. (Note that a separate Apple Lightning-to-
USB 3 Camera Adaptor is required for iOS devices)
2. Verify that the interface is powered ON: Your ConnectAUDIO
2/4
is USB bus-powered and
does not require an external power supply. Once connected, the default indicator lights on the Touch
Panel Display will illuminate, indicating that your ConnectAUDIO
2/4
is powered ON and ready for
use.
3. Check for firmware updates: Go to the iConnectivity support page, download and install the iCon-
fig Configuration and Control software, and open iConfig. iConfig will check the firmware version of
your ConnectAUDIO
2/4
and prompt you to update your firmware if a newer version is available.
iConfig also lets you view information such as the serial number and hardware version of your unit.
Note: We recommend updating to the latest firmware, but you can skip this step and return to it later,
if you prefer.
4. Enable the interface in your DAW:In your DAW, select the ConnectAUDIO
2/4
as the Input and
Output device.
Setting the Output/Phones Level
Once you have hooked up the ConnectAUDIO
2/4
to your device and enabled it in your DAW host soft-
ware, follow these steps to set the Ouput/Phones level:
1. Set up a track in your DAW that contains audio and route it to channels 1/2 of the
ConnectAUDIO
2/4
.
2. Verify that the Phones button LED is green, indicating that channels 1/2 are selected.
3. Touch Out or Phones, according to your monitoring setup; either amplifier/speakers or headphones.
Touch once to enable Signal Level metering mode (green LED). Touch twice to enable Gain Set
metering mode (red LED). Refer to the Out/Phones Meter Modes section below for more information
about meter modes.
4. Verify that the 1 and 2 LEDindicators in the upper-left section of the panel are lit. In Out/Phones
Mode, these buttons represent the stereo linked output. In Out Mode you can select 1 or 2 individually
and adjust each output separately, if you prefer.
12