User Guide

CHAPTER13:MULTI‐ CLOCKCONFIGURATION
Connect‐upto32timeclockstogether,accessedthroughonesoftwareinterface,throughyourlocalarea
networkorovertheInternet.
 ConnectingtheChildClock(s)totheParentClock
 Additionalmulti‐clocksettings
 Updatingthemulti‐clocksystem
 ClockingIn/OutwhentheChildClockisunabletoconnecttotheParentClock
Inamultipleclocksystem,therearetwotypesofclocks:
 ParentClock:TheParentClockhoststhetimeclocksoftware,settings,andpunchdata.Thereisonlyone
ParentClockinamulti‐clockconfiguration.
 ChildClock:AChildClocksendspunch
informationtotheParentClock,overtheNetworkorInternet,for
calculationandstorage.Therecanbeamaximumof31ChildClocksonamulti‐clocksystem.

SYSTEMREQUIREMENTS
 EachtimeclockmustbeconnectedviaEthernettothenetwork.
 EachclockmustberunningthesamesoftwareversionastheParentClock.

CONNECTINGMULTIPLE TIMECLOCKS
SETUP THE PARENTCLOCK
Beforesetupbegins,designatewhichclockwillbetheParentClock.FollowtheinstructionsintheQuickStart
GuidetoconnectyourtimeclocktoyourNetwork.
WritedowntheserialnumberoftheParentClocklocatedonalabelonthebackofthetimeclockterminal.
SETUP THE
CHILDCLOCK(S)
 WiththeChildClockconnectedtotheNetwork,enterSupervisorMode.
 Pressonthetimeclock.
Note:ItisrecommendedthattheParentClockbesetupatthelocationofthepersonprocessingthe
timecards.ForinstructionsonassigningastaticIPaddress,refertoAssignaStaticIPAddresstotheTime
Clock.