User Guide

Look up the Ethernet IP address assigned to the clock. Also, allows for assigning a static IP address, subnet mask,
gateway, and DNS.
 To assign a static IP address, follow the instructions under Assign a Static IP Address to the Time Clock.
 To erase all network settings and revert to DHCP so that the router will assign the IP address, set the IP
address to 000.000.000.000.
VIEW NETWORKS
Allows you to view wireless networks in range, connect to a wireless network, or switch to a different wireless
network. Refer to the Wifi Connection section for instructions on connecting wirelessly.
WPS SETUP
Allows you to connect to a wireless network using WPS. Refer to Chapter 12: Connect to the Clock for instructions
on using WPS connection.
ASSIGN BADGES
This option is used when assigning a proximity badge to an employee. Refer to Assigning Proximity Badges to an
Employee.
SET DATE/TIME
 From Supervisor Mode, scroll through the options using Up or Down until you find the option Set
Date/Time and press Enter.
 The Set Date option displays.
o The Month field flashes. Use Up or Down to select the current month, and press Enter.
o In the Day field, use Up or Down to select the current day of the month and press Enter.
o In the Year field, use Up or Down to select the current year and press Enter.
 The Set Time option displays.
o The Hour field flashes. Use Up or Down to select the current hour and press Enter.
o In the Minute field, use Up or Down to select the current minutes and press Enter.
o In the AM/PM field, use Up or Down to select either A for a.m. or P for p.m. and press Enter.
 Once the new time and date is set, Date/Time and Set Successfully displays on the time clock display. You
are taken back to Supervisor Mode menu. Press Clear to exit Supervisor Mode.
VIEW SERIAL #