User's Manual
Table Of Contents
- Introduction
- What's in the package?
- Register your ICON ProAudio product to your personal account
- Features
- Top Panel Layout
- Rear Panel Layout
- Getting Started
- Connecting Your QconPro X Controller
- Cubase
- Nuendo
- Logic Pro
- Samplitude
- Bitwig
- Reason
- Reaper
- Studio One
- Ableton Live
- Pro Tools
- Download the Mac iMap from your Personal
- User Page at www.iconproaudio.com
- Installing iMapTM Software for Windows
- Assigning DAW Mode (Mackie Control/HUI) or Defining MIDI Functions with iMapTM
- Assigning DAW Mode (Mackie control/HUI) Using iMapTM
- Assigning MIDI Messages in User-Defined Mode Using iMapTM
- Control Element Setup in User-Defined Mode
- Other Functions in iMap™
- Firmware upgrade
- Restore the factory default settings
- Specifications
- Services
- AppendixA
- Cubase
- Logic Pro X
- Pro Tools HUI
- Ableton Live 10
- AppendixB
- Cubase
- Logic Pro X
- Pro Tools HUI
- Ableton Live 10
- AppendixC
- Cubase
- Logic Pro X
- ProTools HUI
- Ableton Live 10
32
Assigning DAW Mode (Mackie control/HUI)
Using iMap
TM
Tip: You may also use the hardware to select DAW instead of through iMap.
Please refer to P.13-14 for instructions.
To begin DAW mode setup, connect your QconPro X with iMap. Follow the
steps below:
1. Connect QconPro X to your Mac/PC
2. Launch iMap and click “Connect Device”
Note: If your QconPro X is not connected to your Mac/PC, the message “There
are no MIDI input devices” will appear. Please connect QconPro X to your
Mac/PC with the provided USB cable.
iMap
TM
QconPro X software panel
Diagram 7