User Guide

Page 8
7 Specification & Features
(Typical conditions @ 235v 50Hz)
• 300B output valves
• 4x 6SN7 (CV181) double triodes
• Low, medium and Zero feedback options
• Icon designed and manufactured Tertiary wound
output transformers
• Hand wired point to point components
• No printed circuit board
• Ceramic valve bases for low noise/leakage
• 32W maximum output 8 Ohms
• 25W maximum output 8 Ohms (Lower HT mode)
• Signal to noise level -88dB
• Freq. response 20Hz -0.2dB to 20kHz -0.5db 8w
• 0.3% THD at 8 watts
• Channel balance typically less than 0.1 dB
• 4 and 8 ohms output taps
• Choke regulated power supply
• Supplied valve cover
• Audiophile quality metal film resistors
• SCR Audiophile polypropylene audio caps
• Optional Mundorf capacitor upgrade
• Japanese ALPS volume pot.
• Rubicon/Nichichron power caps.
• Internal wiring using PTFE silver plated cable
• Valves carefully matched for best performance
• Gold plated Input & speaker terminals
• Line level Inputs for CD, Tuner, Aux, etc
• Record loop with monitor switch
• 140, 300, 790mv sensitivity options
• 230-240volts 50 Hz for EU and UK countries
• 117v 60Hz for USA Canada
• 50 W Standby 150w 0 signal. 235 Watts max
• IEC SKT T3.15A (T5A 117V) fuse (with spare)
• Internal HT fuse 315ma T ceramic. (2x spares)
• 380W, 220H, 380D mm Amp overall 25kg
• Carton= 55x53x38cm 30kg packed
• IEC mains lead
• Conforms to CE ROHS and WEEE where applicable
Specification subject to change without notice.
*RMS watts Do not literally exist! But this figure is based upon the RMS
voltage output (V²/R) to indicate continuous output as opposed to “peak”
output which is mis-leading.
*Triode a simple valve with only 3 elements, this gives very linear
amplification. Some “pentode” (5 element) valves can also be wired to act as
“pseudo” triode valves (not in this amplifier).