User's Guide

4
4.2 LABELS LOCATION
4.2.1 Identification label
4.2.2 Serial number
4.3 SETTINGS
You can set different parameters through 2 encoders allowing 16 positions each (see Tune Up procedure for further
information).
Figure 1: front face Figure 2 : encoders&LEDs
5 PARAMETERS DESCRIPTION
5.1 PARAMETERS
5.1.1 Sensitivity setting
The factory setting fulfills the needs of most of the installations. If the position or the size of the detection area is not
satisfactory, change first the position of the radar (tilt angle and/or height of installation).
5.1.2 Speed thresholds setting
Two relays are available. For each relay, you can choose a speed range for the actuation, defined by a minimum and a
maximum speed threshold.
5.1.3 Direction detection
You can toggle between approaching, receding and two directions detection.
Please don’t remove the
labels!
Once you have set the requested
radar parameters, place the sticker
on the frontface to guarantee its
water tightness.
ATTENTION: manufacturer’s
warranty does not cover radar
without sticker!