User's Guide

2
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference; and,
(2) this device must accept any interference received, including interference that may cause undesired operation. The
device must be located 20cm or more from persons.
The Federal Communications Commission warns that changes or modifications of the unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Unit emits low power microwave radar signals through the front. Do not cover with any labels or block for proper operation.
Keep unit powered off when not in use.
No user serviceable parts inside. Warranty void if opened.
Note: specifications may change without notice.
Note: Not liable for typographical errors or omissions.
The certification of equipment means only that the equipment has met the requirements of the RSS 102 and RSS 210
specifications. License applications, where applicable to use certified equipment, are acted on accordingly by Industry Canada
issuing office and will depend on the existing radio environment, service and location of operation. The certificate is issued on
condition that the holder complies and will continue to comply with the requirements and procedures issued by Industry Canada.
The equipment for which the certificate is issued shall not be manufactured, imported, distributed, leased, offered for sale or
sold unless the equipment complies with the applicable technical specifications and procedures issued by Industry Canada.
La certification du matériel signifie seulement que le matériel a satisfait aux exigences des normes RSS 102 et RSS 210. Les
demandes de licence nécessaires pour l’utilisation du matériel certifié sont traitées en conséquence par le bureau de délivrance
d’Industrie Canada et dépendent des conditions radio ambiantes, du service et de l’emplacement d’exploitation. Le certificat est
délivré à la condition que le titulaire satisfasse et continue de satisfaire aux exigences et aux procédures d’Industrie Canada. Le
matériel à l’égard duquel le certificat est délivré ne doit pas être fabriqué, importé, distribué, loué, mis en vente ou vendu à
moins d’être conforme aux procédures et aux spécifications techniques applicables publiées par Industrie Canada.