Operation Manual

PREPARATION

The 10 digit ATIS (Automatic Transmitter Identiﬁcation Sys-

tem) code can be programmed at power ON.

This initial code setting can be performed only once.

After being set, it can be changed by only your dealer

or distributor. If your ATIS code has already been pro-

grammed, this programming is not necessary.

After programming the MMSI code, “Push [ENTER] to q

Push [ENTER] to start the ATIS code programming. w

 •Push[CLEAR]twicetocanceltheprogramming,andgotothe

normal operating mode. In this case, the ATIS function is dis-

abled. To program the ATIS code, turn OFF the power, then

turn it ON again.

Enter your ATIS code in the following manner: e

 •Selectadesirednumberusing[∫]/[√]/[Ω]/[≈].

 •Push[ENTER]tosetit.

 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push

[ENTER].

Repeat step r e to enter all 10 digits.

After entering the 10 digit code, “FINISH” is automatically t

selected, and then push [ENTER] to set it.

The “ATIS CONFIRMATION” screen is displayed. y

Enter your ATIS code again for confirmation. u

 •Enterinthesamemannerasstepse through t.

When your ATIS code programming is successfully com- i

pleted, the screen as shown below is brieﬂy displayed.

 •Afterthat,thenormaloperatingscreenisdisplayed.

The programmed ATIS code can be checked in the MENU

screen. (p. 77)

ATIS code programming ■ (For Dutch and German versions)