User Manual

49
9
OTHER FUNCTIONS
■ Navigation (Continued)
Start navigating to a Waypoint:
L A Waypoint must be entered before navigating.
1. Push[◄]or[►]todisplay .
2. Push the software key below
.
• The “Waypoint” screen is displayed.
3. Push[▲]or[▼]toselecta
Waypoint.
4. After selecting, push the
softwarekeybelow[NAV]tostart
navigating to the Waypoint.
D Navigation screen description
Range displays the radius of a
compass circle.
Push[▲]or[▼]tochangetherange
between 0.125, 0.25, 0.5, 0.75, 1.5,
3, 6, and 12 nm.
Displays the display’s direction type.
Pushthesoftwarekeybelow[SEL]to
select “N-UP,” “AC-UP,” or “WP-UP.”
LSee page 57 for details.
Thisagiconindicatesthedirectiontoreachthe
target Waypoint or MOB waypoint.
Displays the bearing of the target Waypoint or
MOB waypoint from your vessel.
Displays the Course Over Ground.
Displays the distance to the Waypoint or MOB
waypoint.
Displays the Speed Over Ground.
TIP: Once the navigation starts, it continues even if you
close the Navigation screen by pushing the software key
below[EXIT].Toproperlynishthenavigation,pushthe
softwarekeybelow[FINISH].