User Manual

42
8
DSC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
■ DSC Settings
On the “DSC Settings” screen, you can make settings on
the DSC call related items.
Position Input
See “Entering the position and time” on page 21 for details.
Individual ID
See “Entering an Individual ID” on page 19 for details.
Group ID
See “Entering a Group ID” on page 20 for details.
Auto ACK
The Auto ACK function automatically sends an
Acknowledgement call when the following calls are received.
• Individual call (Default: Differs depending on the version)
• Position Request call (Default: Manual)
• Test call (Default: Auto)
Manual: Manually send an Acknowledgement call.
Auto: Automatically send an Acknowledgement call.
CH Auto Switch (Default: Accept)
Select whether or not to automatically switch to channel
16 or the specied channel, or select whether to switch or
ignore the call.
Accept: After receiving a DSC call, the transceiver remains
on the operating channel for 10 seconds. After
that, the transceiver automatically switches to the
channel that is specied on the DSC call.
Ignore: After receiving a DSC call, if you do not push the
software key below [ACPT] in 10 seconds, the
transceiver ignores the call, and then remains on
the current operating channel.
Manual: After receiving a DSC call, you can select whether
or not to accept the received DSC call.
DSC Switch (Default: On)
Select whether or not to receive and send DSC calls.
L You can send Distress calls despite of this setting.
On: Receives and sends DSC calls.
Off (TEMP): Does not receive or send DSC calls until you
turn OFF the transceiver.
Off: Does not receive or send DSC calls.
TIP: When “Auto” is set to the Individual call, the
Acknowledgement “Unable to Comply” is automatically sent when
the call is received.