User Manual

38
8
DSC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
D Receiving a Position Request call
When a Position Request call is received:
• The alarm sounds for 2 minutes.
• “RCVD POS Request” is displayed.
1. Push any software key to turn OFF the alarm.
2. Push the software key below the intended operation.
[ABLE]
• Sends the Acknowledgement “Able to Comply.”
• The call is saved in the DSC Log.
[UNABL]
• Sends the Acknowledgement “Unable to Comply.”
• Displays the Acknowledgement information, and then
returns to the operating screen by pushing the software
key below [EXIT].
• The call is saved in the DSC Log.
[ACPT]
• Accepts the call.
• Displays the received call’s information.
• The call is saved in the DSC Log.
• Push the software key below [ACK] to send the Position
Reply call. (p. 33)
[IGN]
• Ignores the call and returns to the operating screen.
• The call is saved in the DSC Log.
• “
” blinks continuously until you display the call message.
NOTE:
• If the Auto ACK function is set to “Auto,” the Position
Reply is automatically sent to the calling station. (p. 42)
• However, even if the Auto ACK function is set to
“Manual,” after receiving a Distress Acknowledgement, or
while in the Distress Cancel call procedure, the Position
Reply is automatically sent to the calling station.