User Manual

13
5
BASIC OPERATION
■ Setting the Call channel
By default, a Call channel is set in each Channel Group.
You can set your most often-used channel as your Call
channel in each Channel Group for a quick recall.
1. Push [MENU].
• The Menu screen is displayed.
2. Push [▲] or [▼] to select “Radio Settings,” and then
push [ENT].
• The “Radio Settings” screen is
displayed.
4. Push [▲] or [▼] to select the
channel.
5. Push [ENT] to set the selected
channel as the Call channel.
L Push the software key below
[EXIT] to return to the operating
screen.
■ Adjusting the volume level
1. Push [VOL/SQL].
• The volume level adjustment screen is
displayed.
2. Push [◄] or [►] to adjust the volume
level between 1 and 20, or OFF.
L You can also push the software key
below [MUTE] to select OFF, or below
[LOUD] to set the maximum volume
level.
L If no key is pushed for 5 seconds, the
screen automatically closes.
3. Push [ENT] to set.
■ Adjusting the squelch level
Squelch enables the audio to be heard only while receiving a
signal that is stronger than the set level. A higher level blocks
weak signals, which enables you to receive only stronger
signals. A lower level enables you to hear weak signals.
1. Push [VOL/SQL] twice.
• The squelch level adjustment screen is
displayed.
2. Push [◄] or [►] to adjust the
volume level between 1 and 10, or
Open.
L If no key is pushed for 5 seconds, the
adjustment screen automatically closes.
3. Push [ENT] to set.
3. Push [▲] or [▼] to select “Call
Channel,” and then push [ENT].
• The “Call Channel” screen and the
default Call channel is displayed.