Operation Manual

12
4
BASIC OPERATION
New2001
12
■ Call channel programming
The Call channel key is used to select Channel 9* by default.
However, you can program your most often-used channel in
each channel group for quick recall.
* The channel may differ, depending on the transceiver version.
Hold down q [CH/WX•U/I/C] for 1 second several times to
select the desired channel group
(USA, INT, CAN, ATIS) to
be programmed.
w Hold down [16/C] for 1 second to se-
lect the Call channel.
• “CALL” and Call channel number ap-
pear.
Hold down e [16/C] again for 3 sec-
onds
(until a long beep changes to 2
short beeps) to enter the Call channel
programming mode.
• The Call channel number to be pro-
grammed blinks.
r Push [Y]/[Z] to select the desired
channel.
Push t [16/C] to program the displayed
channel as the Call channel.
• The Call channel number stops blinking.
■ Lock function
This function electronically locks all keys (except for [PTT],
[ ]
and [H/L•LOCK]) to prevent accidental channel changes and
function access.
➥ Push [H/L•LOCK] for 1 second to turn the lock function
ON or OFF.
Hold down
for 1 second
Appears while the loc
k
function is in use.
■ Monitor function
The monitor function releases the noise squelch mute to
check the volume level. See page 27 for details of the monitor
switch action.
➥ Hold down
[
]
for 1 second to activate the monitor func-
tion.
• “ ” and “ ” appear and audio is heard.
Appears while the
monitor function is
in use.
Hold down
for 1 second