Datasheet

Count on us!
www.icom.co.jp/world
www.icomamerica.com
www.icom.net.au
www.icomuk.co.uk
www.icom-france.com
www.icomspain.com
www.icomcanada.com
Your local distributor/dealer:
E-mail: [e-mail]
www.icomeurope.com
1-1-32, Kamiminami, Hirano-Ku, Osaka 547-0003, Japan Phone: [phone] Fax: [phone]
www.bjicom.com
12HS009B © 2012–2018 Icom Inc.
VHF AND UHF TRANSCEIVERS
The approved rating is
Gas: II2G Ex ib IIA T3 Gb
Dust: II2D Ex tb IIIC T160˚C Db IP67
(Tamb= –20˚C to +55˚C)
Special conditions for use: Must be used with BP-227AXD
When the transceiver is used in hazardous areas, either the jack
cover or HM-138 must be attached to the connector.
* Note for IC-F51/F61 ATEX Non-Dust (II2G) version users, please use only the
BP-227AX battery pack with the IC-F51/F61 ATEX Non-Dust version.
ATEX INTRINSICALLY SAFE TYPE APPROVAL
SPEAKER-MICROPHONE
HM-138
SPECIFICATIONS
IC-F51 ATEX
IC-F61 ATEX
IC-F61-L ATEX
GENERAL
Frequency coverage 136–174 MHz
400–470 MHz
350–400 MHz
(Non-RTTE)
Number of channels Max. 128 channels/ 8 zones
Type of emission 16K0F3E, 14K0F3E, 8K50F3E
Channel spacing 12.5/20/25 kHz
12.5/20/25 kHz
12.5/25 kHz
(IC-F61-L)
PLL channel step 2.5/3.125 kHz 5/6.25 kHz
Power supply requirement 7.2 V DC
nominal
Current drain (approx.)
Tx High (at 1 W)
Rx Max. audio
Standby
0.7 A
300 mA
85 mA
0.8 A
300 mA
85 mA
Antenna impedance 50 Ω
(SMA type)
Operating temperature range –20°C to +55°C
Dimensions
(W × H × D)
(Projections not included)
56 × 97 × 36.4 mm (With BP-227AXD)
Weight (approx.) 290 g (With BP-227AXD)
TRANSMITTER
Output power
(at 7.2 V DC) 1 W
Max. frequency deviation ±5.0 kHz/±4.0 kHz/±2.5 kHz
(W/M/N)
Frequency stability ±2.5 ppm
Spurious emissions
0.25 μW
(≤ 1 GHz)
1.0 μW (> 1 GHz)
Modulation limiting 60–100% of Max. deviation
Audio harmonic distortion 3%
typ. (AF 1 kHz 40% deviation)
Ext. microphone connector 9-pin multi connector/2.2 kΩ
RECEIVER
Sensitivity (at 20 dB SINAD) –4 dBμV typ. (emf)
Adjacent channel selectivity 75/73/65 dB min. (W/M/N)
Spurious response 70 dB
Intermodulation rejection 67 dB
typ.
Hum and noise 55/53/50 dB typ. (W/M/N)
Audio output power 500 mW typ. (at 5% distortion with 8 Ω load)
Ext. speaker connector 9-pin multi connector/8 Ω
Measurements made in accordance with EN 300-086.
All stated speci cations are subject to change without notice or obligation.
Applicable U.S. Military Speci cations & IP Rating
Standard
MIL 810 F
Method Procedure
Low Pressure 500.4
I, II
High Temperature 501.4
I, II
Low Temperature 502.4
I, II
Temperature Shock 503.4
I
Solar Radiation 505.4
I
Rain Blowing/Drip 506.4
I, III
Humidity 507.4 –
Salt Fog 509.4 –
Dust Blowing 510.4
I
Vibration 514.5
I
Shock 516.5
I, IV
Also meets equivalent MIL-STD-810-C, -D and -E.
Ingress Protection Standard
Dust & Water IP67 (Dust-protection and waterproof protection)
Charges the BP-227AXD in 9–10
hours. (approx.)
Rapidly charges the BP-227AXD in
2–3 hours. (approx.)
Rapid charges up to 6 battery packs in 2–2.5 hours.
ANTENNAS
FA-S24V: 136–150 MHz (Blue )
FA-S59V: 150–174 MHz (Red)
FA-S27U: 400–470 MHz (Green)
STUBBY ANTENNAS
FA-S62VS: 150–162 MHz (Red)
FA-S63VS: 160–174 MHz (Green)
FA-S57US: 450–490 MHz (Red)
BC-147S*
1
BC-152N
BC-119N+AD-100
BC-121N+AD-100 (6 pcs.)
BATTERY CHARGER*
2
RAPID CHARGER*
2
MULTI-CHARGER*
2
BC-145S*
1
BC-157S
BP-227AXD
Rechargeable Li-ion
7.4 V 1850 mAh (min.)
1950 mAh (typ.)
LEATHER BELT
HANGER
MB-96F
MB-98
Alligator type
BELT CLIPS
MB-86
Swivel type
BATTERY PACK
OPTIONS
Some options may not be available in some countries. Please ask your dealer for details.
*
1
BC-145SA/BC-147SA for 120 V AC. SE for 230 V AC. SV for 240 V AC. BC-145SUK for 230 V AC.
*
2
These chargers are not approved as intrinsically safe. Do not charge the BP-227AXD in an explosive atmosphere.
Supplied accessories: (May differ according to version)
• Battery pack, BP-227AXD • Belt clip, MB-98 • Antenna