Operation Manual

19
4
BIIS OPERATION
4
■ Transmitting a call
A total of 3 ways for code selection are available—selecting
the call code from memory, entering the call code from the
keypad and calling back from the queue channel record.
DD
Using call memory
q While in the standby condition, push [Digital Button] to
enter the call code memory channel selection mode.
•“ ” appears.
w Push [CH Up] or [CH Down] to select the desired call
code.
e Push [Call] or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
WWAAIITT
” is displayed during each call. However, an
error beep sounds and
“
FFAAIILLEEDD
” is displayed when no
answer back is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [Moni(Audi)] to send the ‘Clear down’ signal.
DD
Calling back from the queue channel
q While in the standby condition, push and hold [Digital
Button] for 1 sec. to enter the queue memory channel
selection mode.
w Push [CH Up] or [CH Down] to select the desired record.
e Push [Call] or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
WWAAIITT
” is displayed during each call. However, an
error beep sounds and
“
FFAAIILLEEDD
” is displayed when no
answer back is received after the calls.
r Push [PTT] to transmit; release to receive.
t Push [Moni(Audi)] to send the ‘Clear down’ signal.
< QUEUE >
–QUEUE!–
TXCETXCECALLCALL TXC BIFNBIFN
TXCETXCECALLCALL TXC BIFNBIFN
CALL I NG
0500
Appears