User Guide

75
9
SCAN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Full/band/programmed scan
qPush [VFO] to select VFO mode.
• Select the desired frequency band with [BAND], if desired.
wSet the squelch level.
eWhile pushing and holding [SCAN](2), rotate [DIAL] to se-
lect the desired scanning type.
•“ALL” for full scan; “BAND” for band scan, “PROG-xx (or scan
name if programmed)” for programmed scan (xx= 0 to 24; pro-
grammed scan edges numbers are only displayed), “DUP” (ap-
pears only when duplex operation is set) for duplex scan.
rTo start the scan, release [SCAN](2).
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
• Push [VFO] to stop the scan.
About the scanning steps: The selected tuning step in
each frequency band (in VFO mode) is used during scan.
Duplex scan function: Repeatedly scans two frequencies
(transmission/reception) during duplex scan operation.
FMFM
A
148800
FMFM
A
P SKIPSKIP P SKIPSKIP
P01P01
148800
• During full/band scan • During programmed scan
FMFM
A
145 000
SCAN:ALL
FM
A
148 800
SCAN:BAND
FM
A
148 800
SCAN:PROG-01
P SKIPSKIP
P SKIPSKIP
P SKIPSKIP
• Full scan selection
• Programmed scan selection
• Band scan selection
Selectable between “ 00” to “24”
if programmed.
[DIAL]
FMFM
A
148 800
P SKIPSKIP
P01P01
FMFM
A
148 800
P SKIPSKIP
SCAN:SCANNAME
Scan name
Scan name is not displayed during a programmed scan.
Scan edge number
Scan name selection