User Guide

61
11
OTHER FUNCTIONS
D Cloning using a personal computer
Data can be cloned to and from a personal computer (Mi-
crosoft
®
Windows
®
98/98SE/Me/2000/XP) using the optional
CS-P7
CLONING SOFTWARE and the optional OPC-478/478U
CLONING CABLE . Consult the CS-P7 CLONING SOFTWARE
HELP
file for details.
D Cloning error
NOTE: DO NOT push any key on the sub-transceiver dur-
ing cloning. This will cause a cloning error.
When the display appears as below, a cloning error has oc-
curred.
In such a case, both transceivers automatically return to the
clone standby condition and cloning must be repeated.
■ Auto power-off function
The IC-E7 can be set to automatically turn OFF after a spec-
ified period in which no operation is performed.
120 min., 90 min., 60 min., 30 min. and OFF can be specified.
The specified period is retained even when the transceiver is
turned OFF by the auto power-off function. To cancel the
function, select “OFF” in step e below.
qWhile pushing and holding [FUNC], push and hold
[SQL] (
ATT • SET ) for 1 sec. to enter set mode.
wRotate [DIAL] to select “AP OFF.”
•Turn the expanded set mode ON for selection. (p. 39)
eWhile pushing and holding [FUNC], rotate [DIAL] to select
the desired time or to turn the function OFF.
rPush [SQL] (
ATT • SET ) to exit set mode.
SCAN
S.MW
SET
ATT
DTCS
TSQL
WFMAM
-
DUP
LOW
VOL PRIO P SKIP
MR
5
1
9
ATT
DTCS
T SQL
WFMAM
-
DUP
LOW
VOL PRIOP S KIP
MR
5
1
9
After 1 sec.
SET
[DIAL]
USING
EXPANDED SET MODE
Microsoft and Windows are registered trademarks of Microsoft Corporation in
the U.S.A. and other countries.
ATT
DTCS
T SQL
WFMAM
-
DUP
LOW
VOL PRIO P SKIP
MR
5
1
9
CAUTION: Be sure to turn OFF the transceiver when con-
necting the cloning cable, otherwise cloning op-
erations cannot be performed.